Casting cooling system

The cool basin is ideally suitable, in order to cool the cast part down immediately after the die casting
process. The two metal filters, which can be cleaned depending upon need without large expenditure, are
operated in the change time. The cooling of the basin is made by a tube heat exchanger, which is
attached primarily to the cooling system of the foundry and secondarily by the circulation pump of the cooling
basin. A further metal filter protects the circulation pump before registered Glitter and casting remainders.
By the simple conception those Application a good thing and supports full automation

• 2 metal filter with insert
• 1 plate heat exchanger
• 1 Circulation pump
• Internal PLC with OP77 or relay control
• Complete piping of stainless steel,
• Stainless steel pan with about 1.5 cubic meters of water content,
• Drain valve, level monitoring and

Description of the cooling basin

• Fully automatic cool basin
• PLC control with display over clear text messages
• Unit is ready pre-mounted for operation
• Simple handling